The four guiding blocks (ref. DL-8001254) must be replaced at every annual inspection. They are the highest-frequency consumable in the system — one system = four blocks per year. Replacement is explicitly listed in both ranges' maintenance schedules (DL-6 and AluLIFT). The part is common to both. Keep a few sets in stock at the workshop if you operate more than 5 equipped vehicles.

SRC·FR---Manuel-utilisateur-DL-6.md·l.471-472 + maintenance l.425, l.585

High-frequency consumables: DL-8001254 guiding blocks — set of 4 per system per year; A23 12V batteries for FOB remote — 1 to 2/year per FOB. Fatigue parts to anticipate: DL-8001252 drive gear — replacement every 5 years or 160,000 cycles; AluLIFT balancer — every 1.5 to 2 years. Incident-critical parts: emergency-release cable, 30 A fuse, 2.5 m battery cable. The full motor block is replaced at end-of-system-life (16 years theoretical at standard usage).

SRC·ANALYSIS.md·l.section 3

Parts common to both ranges: motor block, control box, REED limit-switch sensors, FOB remote and A23 battery, battery cable, profile cable, 30 A fuse, DL-8001254 blocks, DL-8001252 drive gear, release key and cylinder. AluLIFT-specific parts: 5 push-button references (DL-8000810/811/814/815/816), spring balancer, door panels, vertical and horizontal rails, cable drums. Note: in EN documentation the drive gear is listed as DL-8002152 — confirm with VanDOOR (likely typo, correct reference is DL-8001252).

SRC·ANALYSIS.md·l.section 2 + 9